Ads
related to: throttle position sensor circuit lowPhone support response time less than 45 seconds - Stella service
Search results
Results from the WOW.Com Content Network
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
The throttle position sensor(s) are continually read and then the software makes appropriate adjustments to reach the desired amount of engine power. There are two primary types of Throttle Position Sensor (TPS): a potentiometer or a non-contact sensor Hall Effect sensor (magnetic device).
This is still present in most transmissions though is no longer necessary to use in most circumstances because the TCU uses the throttle position sensor, the rate of change, and driver characteristics to determine whether a downshift may be necessary, thus eliminating the traditional need for this switch.
Often a throttle position sensor (TPS) is connected to the shaft of the throttle plate to provide the ECU with information on whether the throttle is in the idle position, wide-open throttle (WOT) position, or somewhere in between these extremes. Throttle bodies may also contain valves and adjustments to control the minimum airflow during idle.
Throttle position; Fuel temperature; Exhaust oxygen content (narrowband) Road speed; The intake air mass is measured with a "hot-wire" mass airflow sensor: drawn in by intake manifold vacuum, air moves past an electrically heated wire filament, and the degree to which the filament is cooled indicates the mass of the airstream.
Electronic throttle control, throttle position sensor fault or cruise control failure (see drive by wire) [11] Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of ...
Delco ECU used in General Motors vehicles built in 1996. An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine.
The AMC CEC was unique in that almost all of its sensors and actuators were digital; instead of the usual analog throttle position, coolant temperature, intake temperature, and manifold pressure sensors, it used a set of fixed pressure- and temperature-controlled switches (as well as a wide-open throttle switch on the carburetor) to control ...
Ads
related to: throttle position sensor circuit lowPhone support response time less than 45 seconds - Stella service