Ads
related to: determining proper pushrod length for boat
Search results
Results from the WOW.Com Content Network
In sailing and boating, a vessel's freeboard is the distance from the waterline to the upper deck level, measured at the lowest point of sheer where water can enter the boat or ship. [1] In commercial vessels, the latter criterion measured relative to the ship's load line , regardless of deck arrangements, is the mandated and regulated meaning.
Graphical representation of the dimensions used to describe a ship. Length between perpendiculars (often abbreviated as p/p, p.p., pp, LPP, LBP or Length BPP) is the length of a ship along the summer load line from the forward surface of the stem, or main bow perpendicular member, to the after surface of the sternpost, or main stern perpendicular member.
Used mainly to determine the minimum water depth for safe passage of a vessel and to calculate the vessel's displacement (obtained from ship's stability tables) so as to determine the mass of cargo on board. Draft, Air – Air Draft/Draught is the distance from the water line to the highest point on a ship (including antennas) while it is ...
A vessel's length at the waterline (abbreviated to L.W.L) [1] is the length of a ship or boat at the level where it sits in the water (the waterline). The LWL will be shorter than the length of the boat overall (length overall or LOA) as most boats have bows and stern protrusions that make the LOA greater than the LWL. As a ship becomes more ...
In ISO 8666 for small boats, there is a definition of LOH, or length of hull. [9] This may be shorter than a vessel's LOA, because it excludes other parts attached to the hull, such as bowsprits . LWL
The higher the angular momentum, the greater the resisting force of the gyro to external torque (in this case more ability to cancel boat roll). A gyroscope has three axes: a spin axis, an input axis, and an output axis. The spin axis is the axis about which the flywheel is spinning and is vertical for a boat gyro.
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
The total number vary per the length of a ship. Frame numbers tell you where you are in relation to either the bow or the stern of the ship. [2] The frames support lengthwise members which run parallel to the keel, from the bow to the stern; these may variously be called stringers, strakes, or clamps. [3]
Ads
related to: determining proper pushrod length for boat