enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Gain (antenna) - Wikipedia

    en.wikipedia.org/wiki/Gain_(antenna)

    Rather, it is a comparison between the antenna's gain in each direction to the peak gain of the dipole (1.64). In any direction, therefore, such numbers are 2.15 dB smaller than the gain expressed in dBi.

  3. Minimum detectable signal - Wikipedia

    en.wikipedia.org/wiki/Minimum_detectable_signal

    A minimum detectable signal is a signal at the input of a system whose power allows it to be detected over the background electronic noise of the detector system. It can alternately be defined as a signal that produces a signal-to-noise ratio of a given value m at the output.

  4. Antenna gain-to-noise-temperature - Wikipedia

    en.wikipedia.org/wiki/Antenna_gain-to-noise...

    A parameter often encountered in specification sheets for antennas that operate in certain environments is the ratio of gain of the antenna divided by the antenna temperature (or system temperature if a receiver is specified). This parameter is written as G/T, and has units of dB·K −1. G/T Calculation. G/T is the figure of merit for a ...

  5. Effective radiated power - Wikipedia

    en.wikipedia.org/wiki/Effective_radiated_power

    The ideal dipole antenna could be further replaced by an isotropic radiator (a purely mathematical device which cannot exist in the real world), and the receiver cannot know the difference so long as the input power is increased by 2.15 dB. The distinction between dB d and dB i is often left unstated and the reader is sometimes forced to infer ...

  6. Decibel - Wikipedia

    en.wikipedia.org/wiki/Decibel

    The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...

  7. Signal-to-noise ratio - Wikipedia

    en.wikipedia.org/wiki/Signal-to-noise_ratio

    The OSNR is the ratio between the signal power and the noise power in a given bandwidth. Most commonly a reference bandwidth of 0.1 nm is used. This bandwidth is independent of the modulation format, the frequency and the receiver. For instance an OSNR of 20 dB/0.1 nm could be given, even the signal of 40 GBit DPSK would not fit in this bandwidth.

  8. Return loss - Wikipedia

    en.wikipedia.org/wiki/Return_loss

    In telecommunications, return loss is a measure in relative terms of the power of the signal reflected by a discontinuity in a transmission line or optical fiber.This discontinuity can be caused by a mismatch between the termination or load connected to the line and the characteristic impedance of the line.

  9. Directivity - Wikipedia

    en.wikipedia.org/wiki/Directivity

    The actual result is 34.6380 dBi, just shy of the ideal 35.0745 dBi we expected. [7] Why the difference from the ideal? If the spacing in the x and y dimensions is λ {\displaystyle \lambda } , then the spacing along the diagonals is λ 2 {\displaystyle \lambda {\sqrt {2}}} , thus creating tiny regions in the overall array where photons are ...