enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bevel gear - Wikipedia

    en.wikipedia.org/wiki/Bevel_gear

    Zerol bevel gears are an intermediate type between straight and spiral bevel gears. Their teeth are curved, but not angled. Zerol bevel gears are designed with the intent of duplicating the characteristics of a straight bevel gear, but they are produced using a spiral bevel cutting process.

  3. Miter joint - Wikipedia

    en.wikipedia.org/wiki/Miter_joint

    90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.

  4. Cut Precise Woodworking Angles with These Expert ... - AOL

    www.aol.com/experts-recommend-5-miter-saws...

    Miter saws perform a variety of crosscuts, which sees the cut goes across the grain of a piece of lumber. Their blade also pivots and tilts so that they create accurate angled miter and bevel cuts.

  5. Chamfer - Wikipedia

    en.wikipedia.org/wiki/Chamfer

    A chamfer with a "lark's tongue" finish. A chamfer (/ ˈ ʃ æ m f ər / SHAM-fər or / ˈ tʃ æ m f ər / CHAM-fər) is a transitional edge between two faces of an object.Sometimes defined as a form of bevel, it is often created at a 45° angle between two adjoining right-angled faces.

  6. Gear - Wikipedia

    en.wikipedia.org/wiki/Gear

    Bevel gear operating a lock gate. In a crossed arrangement, the axes of rotation of the two gears are not parallel but cross at an arbitrary angle except zero or 180 degrees. For best operation, each wheel then must be a bevel gear, whose overall shape is like a slice of a cone whose apex is the meeting point of the two axes.

  7. Spiral bevel gear - Wikipedia

    en.wikipedia.org/wiki/Spiral_bevel_gear

    Spiral bevel gear. A spiral bevel gear is a bevel gear with helical teeth. The main application of this is in a vehicle differential, where the direction of drive from the drive shaft must be turned 90 degrees to drive the wheels. The helical design produces less vibration and noise than conventional straight-cut or spur-cut gear with straight ...

  8. Splice joint - Wikipedia

    en.wikipedia.org/wiki/Splice_joint

    The bevel lap is a variation of the half-lap in which the cheeks of the opposing members are cut at an angle of 5 to 10 degrees, sloping back away from the end of the member, so that some resistance to tension is introduced. This helps to prevent the members from being pulled apart.

  9. Table saw - Wikipedia

    en.wikipedia.org/wiki/Table_saw

    Miter gauge: The table has one or two slots (grooves) running from front to back, also parallel to the cutting plane of the blade. These miter slots (or miter grooves) are used to position and guide either a miter gauge (also known as a crosscut fence) or crosscut sled. The miter gauge is usually set to be at 90 degrees to the plane of the ...