Ad
related to: best valve amp under 500 feet chart for 20 meters height
Search results
Results from the WOW.Com Content Network
LEAK TL/12 Point One Amplifier. The first commercially produced amplifier with distortion of 0.1% was the LEAK Type 15 "Point One" of 1945, using KT66 vacuum tubes (valves) connected as triodes, with 26 dB feedback over 4 stages including the output transformer. In 1948 LEAK produced the TL/12 which was also rated at 0.1% but featured improved ...
The tubes best fitting the circlotron concept are triodes designed for use in power supplies as series regulators: 6080/6AS7, 6C33C, 6C19P. An amplifier with one 6AS7 dual triode per channel ( R p = 270 ohms, [ 4 ] μ = 2) will have a Z of about 67 ohms—sufficient to drive most headphones .
The amplifier featured five valves and an output of 10 watts - hence '5-10'. Of those valves, one was a full-wave rectifier (an EZ80 or EZ81), one was a pre-amplifier pentode EF86 and one a double-triode ECC83 as phase splitter. The power amplification was handled by a pair of EL84 working in push-pull configuration.
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
Valves with high g m thus tend to have lower noise at high frequencies. In the audio frequency range (below 1–100 kHz), "1/f" noise becomes dominant, which rises like 1/f. Thus, valves with low noise at high frequency do not necessarily have low noise in the audio frequency range.
It is a sister company to Ashdown Engineering, which makes high-quality, hand-wired, vacuum-tube (or valve in Britain) amplifiers in England. At the end of 2007 it was announced that Dave Green, Matamp's chief engineer, would be joining Hayden full-time as 'Valve Amp Guru'.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
A valve audio amplifier or vacuum tube audio amplifier is a valve amplifier used for sound reinforcement, sound recording and reproduction. Until the invention of solid state devices such as the transistor , all electronic amplification was produced by valve (tube) amplifiers.
Ad
related to: best valve amp under 500 feet chart for 20 meters height