Search results
Results from the WOW.Com Content Network
Heavy construction equipment is usually used due to the amounts of material to be moved — up to millions of cubic metres. Earthwork construction was revolutionized by the development of the scraper and other earth-moving machines such as the loader, the dump truck, the grader, the bulldozer, the backhoe, and the dragline excavator.
Shoring is designed to prevent collapse where shielding is only designed to protect workers when collapses occur. Concrete-structure and stone-building shoring, in these cases also referred to as falsework, provides temporary support until the concrete becomes hard and achieves the desired strength to support loads.
The tieback-deadman structure resists forces that would otherwise cause the wall to lean, as for example, when a seawall is pushed seaward by water trapped on the landward side after a heavy rain. Tiebacks are drilled into soil using a small diameter shaft, and usually installed at an angle of 15 to 45 degrees.
Construction workers who leave the pressurized environment of the caisson must decompress at a rate that allows symptom-free release of inert gases dissolved in the body tissues if they are to avoid decompression sickness, a condition first identified in caisson workers, and originally named "caisson disease" in recognition of the occupational ...
Category for the construction methods involved in the shoring (to avoid collapse of retaining walls) of excavation Subcategories This category has the following 4 subcategories, out of 4 total.
The construction documents, specifically the technical specifications, require the contractor to submit product data, samples, and shop drawings to the architect and engineer for approval. This is one of the first steps that is taken by the contractor after execution of the construction contract and issuance of the "Notice to Proceed".
Continuous flight augering can be used to construct a secant piled wall which can be used as a retaining wall or as shoring during excavation. Once initial piles are set with concrete, other shafts are augured between them, slicing into the original piles, with the new ones receiving rebar .
With the design complete, construction is the next step. Most soil nail wall construction follows a specific procedure. First, a cut is excavated and temporary bracing is put in place if necessary. This is done with conventional earth moving equipment and hydraulic drills.