Search results
Results from the WOW.Com Content Network
In casting, a pattern is a replica of the object to be cast, used to form the sand mould cavity into which molten metal is poured during the casting process. Once the pattern has been used to form the sand mould cavity, the pattern is then removed, molten metal is then poured into the sand mould cavity to produce the casting.
Evaporative-pattern casting is a type of casting process that uses a pattern made from a material that will evaporate when the molten metal is poured into the molding cavity. The most common evaporative-pattern material used is polystyrene foam. [1] The two major evaporative-pattern casting processes are: [1] Lost-foam casting; Full-mold casting
Lost-foam casting is a modern form of investment casting that eliminates certain steps in the process. Investment casting is so named because the process invests (surrounds) the pattern with refractory material to make a mould, and a molten substance is cast into the mold. Materials that can be cast include stainless steel alloys, brass ...
The making of patterns for casting; The making of patterns for sewing This page was last edited on 29 December 2019, at 17:33 (UTC). Text is available under the ...
Lost-foam casting (LFC) is a type of evaporative-pattern casting process that is similar to investment casting except foam is used for the pattern instead of wax. This process takes advantage of the low boiling point of polymer foams to simplify the investment casting process by removing the need to melt the wax out of the mold.
Lost-foam casting – Type of evaporative-pattern casting process; Lost-wax casting – Process by which a duplicate metal sculpture is cast from an original sculpture; Molding (process) – Shaping a liquid or plastic material by making it conform to a more rigid mold; Plaster casting (process) [18] – Sand casting process with use of plaster ...
A core is a device used in casting and moulding processes to produce internal cavities and reentrant angles (an interior angle that is greater than 180°). The core is normally a disposable item that is destroyed to get it out of the piece. [1] They are most commonly used in sand casting, but are also used in die casting and injection moulding.
In the simplest sand casting procedure, the drag is placed upside down on a board, around a pattern of the part to be cast. The pattern is a model of the desired casting. Talcum powder is often dusted over the pattern to aid in the removal of the pattern. Sand is sifted over the pattern until the model is covered by a few inches of sand.