Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture, Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."
A simple rafter roof consists of rafters that the rafter foot rest on horizontal wall plates on top of each wall. [3] The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple.
Roof pitch is the steepness of a roof expressed as a ratio of inch(es) rise per horizontal foot (or their metric equivalent), or as the angle in degrees its surface deviates from the horizontal. A flat roof has a pitch of zero in either instance; all other roofs are pitched .
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
The roof structure is frequently a truss roof supporting purlins or laths, or built using common rafters. Wide buildings with common rafters need interior rows of posts. Sometimes rafters may be attached directly to the poles. The roof pitch of pole buildings is usually low and the roof form is usually gable or lean-to.
The horizontal "fascia board" which caps the end of rafters outside a building may be used to hold the rain gutter. The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the ...
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.