Search results
Results from the WOW.Com Content Network
In 1700, the Italians were the most technologically advanced throwsters in Europe and had developed two machines capable of winding the silk onto bobbins while putting a twist in the thread. They called the throwing machine a filatoio and the doubler a torcitoio. There is an illustration of a circular hand-powered throwing machine drawn in 1487 ...
Spinners keep their fingers wet when spinning, to prevent forming fuzzy thread. Usually singles are spun with an "S" twist. After flax is spun it is washed in a pot of boiling water for a couple of hours to set the twist and reduce fuzziness. Many handspinners will buy a roving of flax. This roving is spun in the same manner as above.
Backing is the rearmost section of the fishing line and typically used only to "pad up" the spool of the fishing reel, in order to prevent unwanted slippage between the mainline and the (usually metallic and well polished) spool surface, increase the effective radius of the spooled line and hence the retrieval speed (i.e. inches per turn), and ...
Spinning reels also tend to have more issues with twisting of the fishing line. Line twist in spinning reels can occur from the spin of an attached lure, the action of the wire bail against the line when engaged by the crank handle, or even retrieval of line that is under load (spinning reel users normally pump the rod up and down, then ...
In 1700, the Italians were the most technologically advanced throwsters in Europe and had developed two machines capable of winding the silk onto bobbins while putting a twist in the thread. They called the throwing machine, a filatoio and the doubler a torcitoio. There is an illustration of a circular hand-powered throwing machine drawn in ...
Thus one can roughly find the number of twists per inch for the single, or one can use the doubled back yarn as a measure. With a thick-and-thin yarn, it is best to count the twist over several inches and average the results. [2] This is because the number of twists per inch will tend to vary between the thin and thick sections.
Unlike bait casting and spin casting reels, the spinning reel hangs beneath the rod rather than sitting on top, and is held in place with a sliding or locking reel seat. The fisherman's second and third fingers straddle the "leg" of the reel where it is attached to the reel seat on the rod, and the weight of the reel hangs beneath the rod ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 12 February 2025. Multi-spool spinning frame Model of spinning jenny in the Museum of Early Industrialisation, Wuppertal, Germany. The spinning jenny is a multi- spindle spinning frame, and was one of the key developments in the industrialisation of textile manufacturing during the early Industrial ...