Search results
Results from the WOW.Com Content Network
Pusher engines mounted on the wing may obstruct sections of the wing trailing edge, reducing the total width available for control surfaces such as flaps and ailerons. When a propeller is mounted in front of the tail, changes in engine power alter the airflow over the tail and can give strong pitch or yaw changes.
Placing engines on the wing provides beneficial wing bending relief in flight. The further the engines are away from the fuselage the greater the wing bending relief, therefore engines mounted close to the fuselage (in the wing root) provide little relief. Almost all modern large jet airplanes use engines in pods located a significant distance ...
A pusher aircraft is a type of aircraft using propellers placed behind the engines and may be classified according to engine/propeller location and drive as well as the lifting surfaces layout (conventional or 3 surface, canard, joined wing, tailless and rotorcraft), Some aircraft have a Push-pull configuration with both tractor and pusher engines.
Low wing: mounted near or below the bottom of the fuselage. Mid wing: mounted approximately halfway up the fuselage. Shoulder wing: mounted on the upper part or "shoulder" of the fuselage, slightly below the top of the fuselage. A shoulder wing is sometimes considered a subtype of high wing. [1] [2] High wing: mounted on the upper fuselage ...
A pusher aircraft is a type of aircraft using propellers placed behind the engines. Pushers may be classified according to lifting surfaces layout (conventional or 3 surface, canard, joined wing, tailless and rotorcraft) as well as engine/propeller location and drive. For historical interest, pusher aircraft are also classified by date.
The T-tail is very common on aircraft with engines mounted in nacelles on a high-winged aircraft or on aircraft with the engines mounted on the rear of the fuselage, as it keeps the tail clear of the jet exhaust. [citation needed] Rear-mounting the engines keeps the wings clean and improves short-field performance. This was necessary in early ...
Push-pull designs have the engines mounted above the wing as Dornier flying boats or more commonly on a shorter fuselage than conventional one, as for Rutan Defiant or Voyager canard designs. Twin boomers such as the Cessna Skymaster and Adam A500 have the aircraft's tail suspended via twin booms behind the pusher propeller.
The Cessna Skymaster is an American twin-engine civil utility aircraft built in a push-pull configuration. Its engines are mounted in the nose and rear of its pod-style fuselage. Twin booms extend aft of the wings to the vertical stabilizers, with the rear engine between them.