Search results
Results from the WOW.Com Content Network
The anchor is shackled to the anchor cable (US anchor chain), the cable passes up through the hawsepipe, through the pawl, over the windlass gypsy (US wildcat) down through the "spurling pipe" to the chain/cable locker under the forecastle (or poop if at the stern (US fantail)) - the anchor bitts are on a bulkhead in the cable locker and the bitter end of the cable is connected to the bitts ...
Also, a wet cable or chain would be difficult to manage. A messenger would then be used as an intermediate device. This was a continuous loop of cable or chain which would go around the capstan. The main anchor cable or chain would then be attached to the messenger for hauling using some temporary connection such as ropes called nippers.
Anchor: a device for holding a boat to the seabed, typically with chain and rope. Traditional anchors include the fisherman, Danforth, and plough types (such as the "CQR" and "Delta"). Recently, far more effective anchors with more reliable holding include the "Rocna" and the "Ultra", both of which are spade anchors.
A very low-power installation is in the chain ferry Föri for up to 75 passengers. It uses battery-supplied twin electric motors. The average power during continuous operation (crossing two minutes and docking one minute) is given as 3 kW in summer and 4 kW in winter with thin ice, thus when moving 4.5 kW in summer and 6 kW in winter.
For a small boat (e.g. 22' / 6.7 m sailing yacht), this might consist of a heavy weight on the seabed, a 12 mm or 14 mm rising chain attached to the "anchor", and a bridle made from 20 mm nylon rope, steel cable, or a 16 mm combination steel wire material. The heavy weight (anchor) should be a dense material.
Holding ground is the area of sea floor that holds an anchor, and thus the attached ship or boat. [4] Different types of anchor are designed to hold in different types of holding ground. [5] Some bottom materials hold better than others; for instance, hard sand holds well, shell holds poorly. [6] Holding ground may be fouled with obstacles. [6]
The anchor chains are pre-tensioned to ensure that the buoy is held in position above the PLEM. As the load from the tanker is applied, the heavy chains on the far side straighten and lift off the seabed to apply the balancing load. Under full design load there is still some 27 metres (89 ft) of chain lying on the bottom.
When a ship anchors in relatively deep water (greater than about 35 metres or 20 fathoms), the anchor and rope that is let down becomes drenched with water, becoming prohibitively difficult to raise again, even with a mechanism like a capstan. This ultimately limits the depths available with ordinary rope to within the weight bearing capacity ...