Search results
Results from the WOW.Com Content Network
So that practical clothing may be described conveniently by a range of small integers, the unit of thermal resistance, to be called the “tog”, is the resistance that will maintain a temperature difference of 0.1°C. with a flux of 1 watt per square metre, or in more practical terms, 10°C. with a flux of 1 watt per square decimetre.
The heat distortion temperature is determined by the following test procedure outlined in ASTM D648. The test specimen is loaded in three-point bending in the edgewise direction. The outer fiber stress used for testing is either 0.455 MPa or 1.82 MPa, and the temperature is increased at 2 °C/min until the specimen deflects 0.25 mm.
A polyester shirt Close-up of a polyester shirt SEM picture of a bend in a high-surface area polyester fiber with a seven-lobed cross section A drop of water on a water resistant polyester Polyesters can contain one ester linkage per repeat unit of the polymer, as in polyhydroxyalkanoates like polylactic acid , or they may have two ester ...
Distortion temperature Polyester: 80–85 °C 230–240 °C Nylon 6 80–85 °C 180–200 °C Nylon 66 90–95 °C 220–235 °C
The glass core has a temperature resistance of up to 550 °C (1022 °F) and the PTFE coating is heat-resistant up to 230 °C (446 °F). Nomex sewing threads are inherently flame-retardant and heat-resistant with a tough protective coating that resists abrasion during the sewing operation. It is temperature resistant up to 370 °C (698 °F).
The RTI is the rounded temperature in degrees C, at which the properties of B have decreased to 50 percent of their initial value in about the same amount of time (correlation time) than it takes for A at its own RTI value. A maximum correlation time of 60.000 hours is considered acceptable for many electrical applications, however it may also ...
Polybutylene terephthalate (PBT) is a thermoplastic engineering polymer that is used as an insulator in the electrical and electronics industries. [2] It is a thermoplastic (semi-)crystalline polymer, and a type of polyester.
The maximum temperature rating of 125 °C also allows SMD film capacitors to be made with PET films. [33] The low cost of polyester and the relatively compact dimensions are the main reasons for the high prevalence of PET film capacitors in modern designs.