Search results
Results from the WOW.Com Content Network
On October 7, 2015, the Commercial division of GE Lighting was separated from the business and a new startup, Current, was created. [9] On July 1, 2020, GE Lighting was acquired by Savant Systems, a home automation company headquartered in Hyannis, Massachusetts, United States. [10] This was General Electric's last consumer business. [11]
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
A solid-state contactor is a heavy-duty solid state relay, including the necessary heat sink, used where frequent on-off cycles are required, such as with electric heaters, small electric motors, and lighting loads. There are no moving parts to wear out and there is no contact bounce due to vibration.
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
High-voltage switchgear A section of a large switchgear panel. Tram switchgear This circuit breaker uses both SF 6 and air as insulation.. In an electric power system, a switchgear is composed of electrical disconnect switches, fuses or circuit breakers used to control, protect and isolate electrical equipment.
Calls from manual offices to panel offices required the "A" board, or outgoing operator, to request the number from the caller, connect to an idle trunk to the distant exchange, and relay the desired number to the B Board Manual Incoming Call operator, who keyed it to the Panel machine for setting up the incoming and final frames to the called ...
Typical domestic panel circuit breakers are rated to interrupt 6 kA (6000 A) short-circuit current. Miniature circuit breakers used to protect control circuits or small appliances may not have sufficient interrupting capacity to use at a panel board; these circuit breakers are called "supplemental circuit protectors" to distinguish them from ...
The most common machine is the impact riveter and the most common use of semi-tubular rivets is in lighting, brakes, ladders, binders, HVAC duct-work, mechanical products, and electronics. They are offered from 1/16-inch (1.6 mm) to 3/8-inch (9.5 mm) in diameter (other sizes are considered highly special) and can be up to 8 inches (203 mm) long.