Search results
Results from the WOW.Com Content Network
Height adjustable suspension is a feature of certain automobile suspension systems that allow the motorist to vary the ride height or ground clearance. This can be done for various reasons including giving better ground clearance over rough terrain, a lower ground clearance to improve performance and fuel economy at high speed, [1] or for stylistic reasons.
The optional FX4 models are basically a standard 4WD with an Off-Road package that includes upgraded heavy-duty Rancho shocks, added skid plates for the fuel tank and transfer case, and two "FX4" decals on both back bedsides instead of the standard "4×4". For all 4WD models, the two-speed transfer case 4×4-LOW range has a gear reduction of 2. ...
Later models would use electronic height sensors and motors so adjustment could be achieved with the engine off. This system allowed the suspension to achieve an unusually soft ride quality. [7] Since then, millions of fairly inexpensive Citroën cars have been equipped with self-levelling as an unobtrusive, but integral design feature.
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
It was launched in May 2002 for the 2003 model year [4] and featured a new four-wheel independent long-travel suspension system, becoming the first full-size sport utility vehicle to use a fully independent suspension. [20] The new independent rear suspension (IRS) was perceived as being controversial by some at the time of its introduction. [21]
The spindle of the shock absorber now became the upper suspension pivot, usually double-ended. One of the last mass-production sports cars to still use lever arm shock absorbers was the MG B. [8] This had a lever arm shock absorber as the upper wishbone. A popular handling upgrade in later years was to fit telescopic shock absorbers instead.
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.