Search results
Results from the WOW.Com Content Network
In such cases the scale is dimensionless and exact throughout the model or drawing. The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale. Thus on an architect's drawing one might read 'one centimeter to one meter', 1:100, 1/100, or 1 / 100 . A bar scale would also ...
An architect's scale is a specialized ruler designed to facilitate the drafting and measuring of architectural drawings, such as floor plans and Multi-view orthographic projections. Because the scale of such drawings is often smaller than life-size, an architect's scale features multiple units of length and proportional length increments. [1]
See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, while Troy weight is the system of mass where 12 troy ounces equals one troy pound. The symbol g 0 is used to denote standard gravity in order to avoid confusion with the (upright) g symbol for gram.
Rulers used in technical drawing are usually made of polystyrene. It is used for drawing lines and connecting points. Rulers come in two types according to the design of their edge. A ruler with a straight edge can be used with lead pencils and felt pens, whereas when a technical pen is used the edge must be grooved to prevent the spread of the ...
And the metric technical pens were chosen in sizes so that one could add detail or drafting changes with a pen width changing by approximately a factor of the square root of 2. A full set of pens would have the following nib sizes: 0.13, 0.18, 0.25, 0.35, 0.5, 0.7, 1.0, 1.5, and 2.0 mm.
Most consumer-level DSLRs, SLTs and mirrorless cameras use relatively large sensors, either somewhat under the size of a frame of APS-C film, with a crop factor of 1.5–1.6; or 30% smaller than that, with a crop factor of 2.0 (this is the Four Thirds System, adopted by OM System (formerly Olympus) and Panasonic).
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
A 1:1 scale construction drawing of a boat and its parts Lines plan A scaled-down version of a full-sized drawing often including the body, plan, profile, and section views Body Plan A view of the boat from both dead ahead and dead astern split in half Plan view A view looking down on the boat from above Profile view A view of the boat from the ...