Search results
Results from the WOW.Com Content Network
The hazards of ammonia solutions depend on the concentration: 'dilute' ammonia solutions are usually 5–10% by weight (< 5.62 mol/L); 'concentrated' solutions are usually prepared at >25% by weight. A 25% (by weight) solution has a density of 0.907 g/cm 3 , and a solution that has a lower density will be more concentrated.
The table above gives properties of the vapor–liquid equilibrium of anhydrous ammonia at various temperatures. The second column is vapor pressure in k Pa . The third column is the density of the liquid phase.
Household ammonia ranges in concentration by weight from 5% to 10% ammonia. [9] Because aqueous ammonia is a gas dissolved in water, as the water evaporates from a surface, the gas evaporates also, leaving the surface streak-free. Its most common uses are to clean glass [10], porcelain, and stainless steel. It is good at removing grease and is ...
The density of propane gas at 25 °C (77 °F) is 1.808 kg/m 3, about 1.5× the density of air at the same temperature. The density of liquid propane at 25 °C (77 °F) is 0.493 g/cm 3, which is equivalent to 4.11 pounds per U.S. liquid gallon or 493 g/L. Propane expands at 1.5% per 10 °F. Thus, liquid propane has a density of approximately 4.2 ...
(fluid) 1.6 ε 0 at 0 °C ... b = 0.08445 liter per mole ... Propane does not have health effects other than the danger of frostbite or asphyxiation.
The energy content of ethanol is 76,100 BTU/US gal (5.89 kilowatt-hours per litre), compared to 114,100 BTU/US gal (8.83 kWh/L) for gasoline. (see chart above) A flex-fuel vehicle will experience about 76% of the fuel mileage MPG when using E85 (85% ethanol) products as compared to 100% gasoline.
Anhydrous solvents are commercially available from chemical suppliers, and are packaged in sealed containers to maintain dryness. [4] Typically anhydrous solvents will contain approximately 10 ppm of water and will increase in wetness if they are not properly stored. Organic solutions can be dried using a range of drying agents.
The amount of mass that can be lifted by hydrogen in air per unit volume at sea level, equal to the density difference between hydrogen and air, is: (1.292 - 0.090) kg/m 3 = 1.202 kg/m 3. and the buoyant force for one m 3 of hydrogen in air at sea level is: 1 m 3 × 1.202 kg/m 3 × 9.8 N/kg= 11.8 N