Ads
related to: rf cable vs coaxial switch boxcrutchfield.com has been visited by 100K+ users in the past month
- A/V Cables
Complete Your System with Quality
Cables and Power Protection
- Home Theater
A/V Gear to Bring the Movie Theater
Experience into Your Living Room
- Home Receivers
Building an Audio System or a Home
Theater? Our Experts Can Help
- A/V Receivers
Power for All Your Speakers and
Connections for All Your A/V Gear
- A/V Cables
ebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
An RF connector (radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range. RF connectors are typically used with coaxial cables and are designed to maintain the shielding that the coaxial design offers.
A PIN Diode RF Microwave Switch. There are two types of switches typically used in switch matrices: Coaxial Electromechanical Switches and Solid State Switches, also known as electronic switches. Coaxial electromechanical switches can be further divided into two categories based on their architecture, latching relay and non-latching relay.
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...
The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.
Ads
related to: rf cable vs coaxial switch boxcrutchfield.com has been visited by 100K+ users in the past month
ebay.com has been visited by 1M+ users in the past month