Ads
related to: class 1 div 2 enclosure requirementszoro.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
Each type specifies characteristics of an enclosure, but not, for example, a specific enclosure size. Note that higher numbers do not include the lower-numbered tests. For example, types 3, 4 and 6 are intended for outdoor use, but type 5 is not. A NEMA enclosure rating does not mean that it also meets the same UL enclosure rating. [2]
In Europe, a double insulated appliance must be labelled Class II or double insulated or bear the double insulation symbol: ⧈ (a square inside another square). As such, the appliance should not be connected to an earth conductor because the high-impedance casing will cause only low-fault currents that are unable to trigger the fusible cut-out.
The enclosure is the only part of the equipment which is seen by users. It may be designed not only for its utilitarian requirements, but also to be pleasing to the eye. Regulations may dictate the features and performance of enclosures for electrical equipment in hazardous areas, such as petrochemical plants or coal mines.
Class 1 goods are subdivided further into one of 6 distinct divisions, that describes the predominant explosive hazard that exists if that article was to detonate or activate while in transport or storage. These divisions are as follows: Class 1: Explosives. Division 1.1: Explosive that has a mass explosion hazard. A mass explosion is a ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1]
The European Standard EN 62262 — the equivalent of international standard IEC 62262 (2002) — relates to IK (impact protection) ratings. [1] This is an international numeric classification for the degrees of protection provided by enclosures for electrical equipment against external mechanical impacts.
Ads
related to: class 1 div 2 enclosure requirementszoro.com has been visited by 100K+ users in the past month