Search results
Results from the WOW.Com Content Network
The first starting and charging systems were designed to be 6-volt and positive-ground systems, with the vehicle's chassis directly connected to the positive battery terminal. [10] Today, almost all road vehicles have a negative ground system. [11] The negative battery terminal is connected to the car's chassis.
from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V relay 31b return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33 main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g 3. slow ...
General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.
The ECU constantly monitors the rotational speed of each wheel; if it detects the wheel rotating significantly slower than the speed of the vehicle, a condition indicative of impending wheel lock, it actuates the valves to reduce hydraulic pressure to the brake at the affected wheel, thus reducing the braking force on that wheel; the wheel then ...
Boosting a dead battery through a battery charger can take anywhere from five to twenty minutes depending on the depth-of-discharge (DOD), health of the vehicle battery, and type of engine (engine displacement). AC power is not usually available for a roadside boost. Jump starters are portable battery devices that allow for jump starting of ...
Center axle disconnect on a Dana 60, in a 1999 4x4 Dodge 2500HD. A center axle disconnect system or CAD is an alternative to locking hubs. CAD systems are typically used in front drive axles on four wheel drive vehicles. A CAD system works by having an axle shaft (typically the longer shaft) split into two pieces.
Slipping the clutch is a popular term in drag racing culture and is done when launching a car, usually in a drag race. Some contend that slipping the clutch is the best way to launch a front-wheel drive (FWD) car as it prevents torque steering that many FWD cars experience when too much power is put to the front wheels.
The terminal must be placed into the appropriately sized crimp barrel. The wire is then inserted into the terminal with the end of the wire flush with the exit of the terminal to maximize cross-sectional contact. Finally, the handles of the crimp tool are used to compress and reshape the terminal until it is cold-welded onto the wire. [3]