Search results
Results from the WOW.Com Content Network
However, a transformer may include a tap changer on each winding if there are advantages to do so. For example, in power distribution networks, a large step-down transformer may have an off-load tap changer on the primary winding and an on load automatic tap changer on the secondary winding or windings. The high voltage tap is set to match long ...
Both linear spacing and power-of-two-style Vernier spacing can be employed in establishing the tap positions, e.g., a four-tap transformer can provide taps at 0.25, 0.5, 0.75, 1.0 (linear) or 0.0625, 0.125, 0.25, and 0.5 (Vernier). (The limitations of the Vernier—in this case, that the maximum obtainable amplitude is 0.9375—are less ...
In switch-mode power supplies, center-tapped transformers are often used, sometimes with single diodes or a dual diode half-bridge [2] to optimize their dynamic electromagnetic behavior at the expense of the extra windings. [3] Phantom power can be supplied to a condenser microphone using center tap transformers. One method, called "direct ...
A leakage transformer, also called a stray-field transformer, has a significantly higher leakage inductance than other transformers, sometimes increased by a magnetic bypass or shunt in its core between primary and secondary, which is sometimes adjustable with a set screw. This provides a transformer with an inherent current limitation due to ...
center tap A connection on a transformer which has equal voltage to either end of the transformer winding. ceramic resonator A piezoelectric element used to stabilize the frequency of an oscillator. channel Any communication path between a signal transmitter and a signal receiver, or, a pre-selected operating frequency for a radio system.
In electrical engineering, an autotransformer is an electrical transformer with only one winding. The "auto" (Greek for "self") prefix refers to the single coil acting alone. In an autotransformer, portions of the same winding act as both the primary winding and secondary winding sides of the transformer. In contrast, an ordinary transformer ...
Typical multi-tap buck–boost transformer. A buck–boost transformer is a type of transformer used to make adjustments to the voltage applied to alternating current equipment. [1] Buck–boost connections are used in several places such as uninterruptible power supply (UPS) units for computers and in the tanning bed industry.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...