enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Some 2-hole punches have an "888" marking on their paper guide, to assist punching all four holes into A4 paper. [ 5 ] Konica Minolta specifies that for European 4-hole arrangements, all holes should be 11 ± 1 mm from the nearest (i.e. long/spine) edge of the paper, [ 6 ] which is slightly at variance with ISO 838's specification of 12 ± 1 mm .

3. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

4. Keypunch - Wikipedia

   en.wikipedia.org/wiki/Keypunch

   Punch cards were stepped across the punch one column at a time, and the appropriate punches were activated to create the holes, resulting in a distinctive "chunk, chunk" sound as columns were punched. Both machines could process 51-, 60-, 66-, and 80-column cards. [20] The 026 could print the punched character above each column.

5. Punched tape - Wikipedia

   en.wikipedia.org/wiki/Punched_tape

   Punched tape or perforated paper tape is a form of data storage device that consists of a long strip of paper through which small holes are punched. It was developed from and was subsequently used alongside punched cards , the difference being that the tape is continuous.

6. Punched card - Wikipedia

   en.wikipedia.org/wiki/Punched_card

   Card size is 7 + 3 ⁄ 8 by 3 + 1 ⁄ 4 inches (187 by 83 mm). The cards are made of smooth stock, 0.007 inches (180 μm) thick. There are about 143 cards to the inch (56/cm). In 1964, IBM changed from square to round corners. [49] They come typically in boxes of 2,000 cards [50] or as continuous form cards. Continuous form cards could be both ...

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet. A punch that is significantly smaller than the die can be used to produce an extruded hole where the punch displaces the punched material to the sides, forming a tube perpendicular to the punched sheet. [2] [3]