enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Some 2-hole punches have an "888" marking on their paper guide, to assist punching all four holes into A4 paper. [ 5 ] Konica Minolta specifies that for European 4-hole arrangements, all holes should be 11 ± 1 mm from the nearest (i.e. long/spine) edge of the paper, [ 6 ] which is slightly at variance with ISO 838's specification of 12 ± 1 mm .

3. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

4. Floppy disk - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk

   8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...

5. Punched tape - Wikipedia

   en.wikipedia.org/wiki/Punched_tape

   Tape for punching was usually 0.00394 inches (0.100 mm) thick. The two most common widths were 11 ⁄ 16 inch (17 mm) for five bit codes, and 1 inch (25 mm) for tapes with six or more bits. Hole spacing was 0.1 inches (2.5 mm) in both directions. Data holes were 0.072 inches (1.8 mm) in diameter; sprocket feed holes were 0.046 inches (1.2 mm). [8]

6. What will happen to Social Security under Trump’s tax plan?

   www.aol.com/finance/happen-social-security-under...

   According to the Tax Foundation, Trump’s proposed tax cut would reduce tax revenue by about $1.4 trillion from 2025 to 2034, measured on a conventional basis.

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet. A punch that is significantly smaller than the die can be used to produce an extruded hole where the punch displaces the punched material to the sides, forming a tube perpendicular to the punched sheet. [2] [3]