Search results
Results from the WOW.Com Content Network
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).
The ratio is determined by the ratio of the distances from the rocker arm's pivot point to the point where it touches the valve and the point where it touches the pushrod/camshaft. A rocker ratio greater than one essentially increases the camshaft's lift. Current automotive design favors rocker arm ratios of about 1.5:1 to 1.8:1.
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter, upon which the camshaft makes contact. The camshaft lobe moves the lifter upwards, which moves the ...
Though it is true that some OHC engines do come close to the high moving part count of an OHV engine it is very rare. The Honda SOHC C series V6 engines for example had a pushrod and two rockers just for the exhaust valve. Yes OHV designs can have some of the same configurations as OHC engines but OHV engines simply do not have the same ...
The lobed camshaft rhythmically presses against the lifter, which transmits the motion to the engine valve in one of two ways: through a pushrod which actuates the valve via a rocker mechanism (in an overhead valve (OHV) engine); via direct contact with the valve stem or rocker arm (in an overhead camshaft (OHC) configuration).
Most modern pushrod engines have two valves per cylinder, while many OHC engines can have three, four or even five valves per cylinder to achieve greater efficiency and power. Recently, however, GM has begun offering a pushrod V6 with VVT, and Cummins' ISB is a 4-valve pushrod straight-6. The GM 3900 was the first mass-produced pushrod engine ...
1963 Jeep Tornado engine. The Jeep Tornado engine was the first post-World War II U.S.-designed mass-produced overhead cam (OHC) automobile engine. [1] The 230.5 cu in (3.78 L) hemi-headed straight-six was introduced in mid-year 1962, and replaced the flathead "6-226" Willys Super Hurricane that was in use since 1954.