Search results
Results from the WOW.Com Content Network
OEM Bluetooth Serial Module is a chip to embed Bluetooth connection directly onto the circuit boards of RS232 based equipment. Bluetooth Serial Module can be connected to the device via built-in UART interface and communicate with other Bluetooth enabled devices such as mobile phones, handheld computers and laptops. [citation needed]
The drivers for a software-implemented modem create a virtual serial port for communication with the host operating system, since the modem is implemented entirely in the device driver and therefore there is no point where the serial data would be sent to the physical card.
Common Hybrid Interface Protocol System (CHIPS) is the definition of a computer network that consists of a mixture of common serial data protocols such as RS-232 and RS-485, or can be even PC keyboard interface communication. CHIPS may also consist of Bluetooth and Wi-Fi for wireless communication can be installed on all major hardware platforms.
COM (communication port) [1] [2] is the original, yet still common, name of the serial port interface on PC-compatible computers. It can refer not only to physical ports, but also to emulated ports, such as ports created by Bluetooth or USB adapters .
The Bluetooth protocol RFCOMM is a simple set of transport protocols, made on top of the L2CAP protocol, providing emulated RS-232 serial ports (up to sixty simultaneous connections to a Bluetooth device at a time). The protocol is based on the ETSI standard TS 07.10.
The ELM327 abstracts the low-level protocol and presents a simple interface that can be called via a UART, typically by a hand-held diagnostic tool or a computer program connected by USB, RS-232, Bluetooth or Wi-Fi. [2] New applications include smartphones. [3] There are a large number of programs available that connect to the ELM327. [4] [5]
In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data. It formally defines signals connecting between a DTE ( data terminal equipment ) such as a computer terminal or PC , and a DCE ( data circuit-terminating equipment or data communication ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...