Search results
Results from the WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada [1]. It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters .
Simplifications have used a formula involving the board ECT, the board thickness, and the box perimeter. Most estimations do not relate well to other box orientations, box styles, or to filled boxes. In order to calculate the value of BCT ( Box compression test ), the formula of McKee would be the easiest but also the least accurate [ opinion ] .
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
The size of wafers for photovoltaics is 100–200 mm square and the thickness is 100–500 μm. [10] Electronics use wafer sizes from 100 to 450 mm diameter. The largest wafers made have a diameter of 450 mm, [11] but are not yet in general use.
In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16 ...
A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It is equal to π /4 square mils or approximately 5.067 × 10 −4 mm 2. It is a unit intended for referring to the area of a wire with a circular cross section.
From January 2008 to December 2012, if you bought shares in companies when Kelvin R. Westbrook joined the board, and sold them when he left, you would have a -40.9 percent return on your investment, compared to a -2.8 percent return from the S&P 500.
The pressing cycle operates in stages, with the mat thickness being first compressed to around 1.5 times the finished board thickness, then compressed further in stages and held for a short period. This gives a board profile with zones of increased density, thus mechanical strength, near the two faces of the board and a less dense core. [9]