Search results
Results from the WOW.Com Content Network
Pearlite is a two-phased, lamellar (or layered) structure composed of alternating layers of ferrite (87.5 wt%) and cementite (12.5 wt%) that occurs in some steels and cast irons. During slow cooling of an iron-carbon alloy, pearlite forms by a eutectoid reaction as austenite cools below 723 °C (1,333 °F) (the eutectoid temperature).
When using the chart, it is important to remember these tips: Isotropic and opaque (metallic) minerals cannot be identified this way. The stage of the microscope should be rotated until maximum colour is found, and therefore, the maximum birefringence. Each mineral, depending on the orientation, may not exhibit the maximum birefringence.
This glossary of biology terms is a list of definitions of fundamental terms and concepts used in biology, the study of life and of living organisms.It is intended as introductory material for novices; for more specific and technical definitions from sub-disciplines and related fields, see Glossary of cell biology, Glossary of genetics, Glossary of evolutionary biology, Glossary of ecology ...
This increases the brittleness of the steel in a way that can only be relieved by recrystallizing. Widmanstätten structures made from ferrite sometimes occur in carbon steel, if the carbon content is below but near the eutectoid composition (~ 0.8% carbon). This occurs as long needles of ferrite within the pearlite. [16]
Under a light microscope, the microstructure of bainite appears darker than untempered martensite because the bainite has more substructure. [9] The hardness of bainite can be between that of pearlite and untempered martensite in the same steel hardness. The fact that it can be produced during both isothermal or continuous cooling is a big ...
[2] [3] Acicular ferrite is a fine Widmanstätten constituent, which is nucleated by an optimum intragranular dispersion of oxide/sulfide/silicate particles. The interlocking nature of acicular ferrite, together with its fine grain size (0.5 to 5 μm with aspect ratio from 3:1 to 10:1), provides maximum resistance to crack propagation by cleavage.
A very rapid quench is essential to create martensite. For a eutectoid carbon steel of thin section, if the quench starting at 750 °C and ending at 450 °C takes place in 0.7 seconds (a rate of 430 °C/s) no pearlite will form, and the steel will be martensitic with small amounts of retained austenite. [2]
In the iron–carbon system (i.e. plain-carbon steels and cast irons) it is a common constituent because ferrite can contain at most 0.02wt% of uncombined carbon. [6] Therefore, in carbon steels and cast irons that are slowly cooled, a portion of the carbon is in the form of cementite. [ 7 ]