Search results
Results from the WOW.Com Content Network
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
Pavilion roof : A low-pitched roof hipped equally on all sides and centered over a square or regular polygonal floor plan. [10] The sloping sides rise to a peak. For steep tower roof variants use Pyramid roof. Pyramid roof: A steep hip roof on a square building.
The 90-degree complement to the angle of incidence is called the grazing angle or glancing angle. Incidence at small grazing angles is called "grazing incidence." [citation needed] Grazing incidence diffraction is used in X-ray spectroscopy and atom optics, where significant reflection can be achieved only at small values of the grazing angle.
The diaphragm of a structure often does double duty as the floor system or roof system in a building, or the deck of a bridge, which simultaneously supports gravity loads. [1] Parts of a diaphragm include: [2] the collector (or membrane), used as a shear panel to carry in-plane shear
The angle of incidence, α, is close to the critical angle for the sample. The beam is diffracted in the plane of the surface of the sample by the angle 2θ, and often also out of the plane. Grazing incidence diffraction ( GID ) is a technique for interrogating a material using small incidence angles for an incoming wave, often leading to the ...
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
The oldest surviving framed house in North America, the Fairbanks House, has an ell with a gambrel roof, but this roof was a later addition. Claims to the origin of the gambrel roof form in North America include: Indigenous tribes of the Pacific Northwest, the Coast Salish, used gambrel roof form (Suttle & Lane (1990), p. 491). [10]
A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...