Search results
Results from the WOW.Com Content Network
Reasons for measuring throughput in networks. People are often concerned about measuring the maximum data throughput in bits per second of a communications link or network access. A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or ...
The asymptotic throughput (less formal asymptotic bandwidth) for a packet-mode communication network is the value of the maximum throughput function, when the incoming network load approaches infinity, either due to a message size, [3] or the number of data sources.
There are many different ways to measure the performance of a network, as each network is different in nature and design. Performance can also be modeled and simulated instead of measured; one example of this is using state transition diagrams to model queuing performance or to use a Network Simulator.
In data communications, the bandwidth-delay product is the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds). [1] The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged.
Network performance could be measured using either active or passive techniques. Active techniques (e.g. Iperf) are more intrusive but are arguably more accurate. Passive techniques have less network overhead and hence can run in the background to be used to trigger network management actions.
For example, the sample diagram does not indicate the physical type of connection between the PCs and the switch, but since a modern LAN is depicted, Ethernet may be assumed. If the same style of line was used in a WAN (wide area network) diagram, however, it may indicate a different type of connection.
The link spectral efficiency of a digital communication system is measured in bit/s/Hz, [2] or, less frequently but unambiguously, in (bit/s)/Hz.It is the net bit rate (useful information rate excluding error-correcting codes) or maximum throughput divided by the bandwidth in hertz of a communication channel or a data link.
Based on Bill Dally's analysis of latency, average-case throughput, and hot-spot throughput of m-ary n-cube networks [2] for various m, it can be observed that low-dimensional networks, in comparison to high-dimensional networks (e.g., binary n-cubes) with the same bisection bandwidth (e.g., tori), have reduced latency and higher hot-spot ...