Search results
Results from the WOW.Com Content Network
A drop test is a method of testing the in-flight characteristics of prototype or experimental aircraft and spacecraft by raising the test vehicle to a specific altitude and then releasing it. Test flights involving powered aircraft, particularly rocket-powered aircraft , may be referred to as drop launches due to the launch of the aircraft's ...
MIL-STD-810, U.S. Department of Defense Test Method Standard, Environmental Engineering Considerations and Laboratory Tests, is a United States Military Standard that emphasizes tailoring an equipment's environmental design and test limits to the conditions that it will experience throughout its service life, and establishing chamber test ...
Instrumented drop test of cushioned package to measure the transmitted shock Both primary (consumer) packages and shipping containers have a risk of being dropped or being impacted by other items. Package integrity and product protection are important packaging functions.
A stress test (sometimes called a torture test) of hardware is a form of deliberately intense and thorough testing used to determine the stability of a given system or entity. It involves testing beyond normal operational capacity , often to a breaking point, in order to observe the results.
In materials science, the Charpy impact test, also known as the Charpy V-notch test, is a standardized high strain rate test which determines the amount of energy absorbed by a material during fracture. Absorbed energy is a measure of the material's notch toughness. It is widely used in industry, since it is easy to prepare and conduct and ...
The International Follow-On Structural Fatigue Test Program (IFOSTP) was a joint venture between Australia, Canada and the U.S. to fatigue test the F/A-18 Hornet. The Australian test involved the use of electrodynamic shakers and pneumatic airbags to simulate high angle of attack buffet loads over the empennage. [13] [14]
A test of "single" standard rope involves tying an 80 kg (176 pound) weight to the end of a length of rope. This weight is then dropped 5 meters (16½ feet) on 2.7 meters (9 feet) of rope, with the rope running over a rounded surface simulating that of a standard carabiner. This process is repeated until the rope breaks.
The dropping point test procedures are given in ASTM standards D-566 [2] and D-2265. [3] The test apparatus consists of a grease cup with a small hole in the bottom, test tube, two thermometers, a container, stirring device if required and an electric heater. The inside surfaces of the grease cup are coated with the grease to be tested.