Search results
Results from the WOW.Com Content Network
Å3 = Å 3 • [1] fb-1 = fb −1 • [1] m-1 = m −1 • [1] m-2 = m −2 • [1] m-3 = m −3 • [1] km2 = km 2 • [1e6] km3 = km 3 • [1e9] µm2 = µm 2 ...
Calcium and magnesium ions present as sulfates, chlorides, carbonates and bicarbonates cause water to be hard. Water chemists measure water impurities in parts per million (ppm).
Cholinesterase inhibition was observed at all dose levels tested, and a NOAEL of 0.03 mg/kg/day estimated by dividing a LOAEL of 0.3 mg/kg/day by an uncertainty factor of 10. As with the acute RfD, the chronic RfD of 3×10 −4 mg/kg/day was determined by dividing this NOAEL by the inter- and intraspecies uncertainty factors.
A box of .38 Special (9.1 mm) cartridges that have 148-grain (9.6 g) bullets. Grains are commonly used to measure the mass of bullets and propellants. [11] [12] In archery, the grain is the standard unit used to weigh arrows.
Normality is defined as the number of gram or mole equivalents of solute present in one liter of solution.The SI unit of normality is equivalents per liter (Eq/L). = where N is normality, m sol is the mass of solute in grams, EW sol is the equivalent weight of solute, and V soln is the volume of the entire solution in liters.
1 mmol/L is equivalent to 100.09 mg/L CaCO 3 or 40.08 mg/L Ca 2+. A degree of General Hardness ( dGH or 'German degree' (°dH, deutsche Härte )) is defined as 10 mg/L CaO or 17.848 ppm. A Clark degree (°Clark) or English degree (°e or e) is defined as one grain (64.8 mg) of CaCO 3 per Imperial gallon (4.55 litres) of water, equivalent to 14. ...
The calculated CT value is the product of the disinfectant residual (in mg/L) and the detention time (in minutes), through the section at peak hourly flow. [5] These tables express the required CT values to achieve a desired removal of microorganisms of interest in drinking water (e.g. Giardia lamblia cysts) for a given disinfectant under ...
Densities using the following metric units all have exactly the same numerical value, one thousandth of the value in (kg/m 3). Liquid water has a density of about 1 kg/dm 3, making any of these SI units numerically convenient to use as most solids and liquids have densities between 0.1 and 20 kg/dm 3. kilogram per cubic decimetre (kg/dm 3)