Search results
Results from the WOW.Com Content Network
For an NPN open emitter output, the collector is connected to the positive voltage rail, so the emitter outputs a high voltage when the transistor is on and is hi-Z when off. For a PNP open emitter output, the collector is connected to the low voltage supply, so the emitter outputs a low voltage when the transistor is on and is hi-Z when off.
Wired logic works by exploiting the high impedance of open collector outputs (and its variants: open emitter, open drain, or open source) by just adding a pull-up or pull-down resistor to a voltage source, or can be applied to push-pull outputs by using diode logic (with the disadvantage of incurring a diode drop voltage loss).
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
The heart of an I2L circuit is the common emitter open collector inverter. Typically, an inverter consists of an NPN transistor with the emitter connected to ground and the base biased with a forward current from the current source. The input is supplied to the base as either a current sink (low logic level) or as a high-z floating condition ...
Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.
Mexico has asked the United States to extradite the suspected mastermind behind the murder of journalist Javier Valdez after he was arrested on drug charges, the attorney general said. Damaso ...
The input signal is applied across the ground and the base circuit of the transistor. The output signal appears across ground and the collector of the transistor. Since the emitter is connected to the ground, it is common to signals, input and output. The common-emitter circuit is the most widely used of junction transistor amplifiers.
With a few weeks left in the season, let's assign grades to the trades that were made after Week 1. Like NFL Draft grades, the immediate grades for trades can be fun and informative too.