Search results
Results from the WOW.Com Content Network
An example schematic with one controller (a microcontroller), three target nodes (an ADC, a DAC, and a microcontroller), and pull-up resistors R p. I 2 C uses only two signals: serial data line (SDA) and serial clock line (SCL). Both are bidirectional and pulled up with resistors. [2]
An example of a USART. A universal synchronous and asynchronous receiver-transmitter (USART, programmable communications interface or PCI) [1] is a type of a serial interface device that can be programmed to communicate asynchronously or synchronously.
Universal EXTension (UEXT) is a connector layout which includes power and three serial buses: Asynchronous, I 2 C, and SPI separately over 10 pins in a 2×5 layout. The connector layout was specified by Olimex Ltd and declared an open-project that is royalty-free in 2011, and was used in all their boards after 2004.
Block diagram of an HD44780U-based LCD module. The Hitachi HD44780 LCD controller is limited to monochrome text displays and is often used in copiers, fax machines, laser printers, industrial test equipment, and networking equipment, such as routers and storage devices. Compatible LCD screens are manufactured in several standard configurations.
In telecommunications, an eye pattern, also known as an eye diagram, is an oscilloscope display in which a digital signal from a receiver is repetitively sampled and applied to the vertical input (y-axis), while the data rate is used to trigger the horizontal sweep (x-axis). It is so called because, for several types of coding, the pattern ...
Before signaling will work, the sender and receiver must agree on the signaling parameters: Full or half-duplex operationThe number of bits per character -- currently almost always 8-bit characters, but historically some transmitters have used a five-bit character code, six-bit character code, or a 7-bit ASCII.
MII has two signal interfaces: A Data interface to the Ethernet MAC, for sending and receiving Ethernet frame data. A PHY management interface, MDIO, used to read and write the control and status registers of the PHY in order to configure each PHY before operation, and to monitor link status during operation.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.