Ads
related to: duct booster fan catalogebay.com has been visited by 1M+ users in the past month
northerntool.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
The high-bypass turbofan engines used on many modern airliners is an example of a very successful and popular use of ducted fan design. The duct increases thrust efficiency by up to 90% in most cases [citation needed], in comparison to a similar-sized propeller in free air. Ducted fans are quieter, and offer good opportunities for thrust vectoring.
About 70% of the air passing through the fan goes down the bypass duct. The JT15D-4 and later variants use a "booster" axial stage behind the fan which runs at the same speed as the fan and directs the remaining 30% of the air into the high-pressure compressor, after which it passes into a reverse-flow annular combustor. The hot gases flow ...
A "cropped fan" derivative of the -2, the -3 engine has a smaller fan diameter at 60 in (1.5 m) but retains the original basic engine layout. The new fan was primarily derived from GE's CF6-80 turbofan rather than the CFM56-2, and the booster was redesigned to match the new fan. [26]
Aircraft whose primary form of thrust is derived from a piston engine, rotary engine or turboshaft driving a ducted fan. Subcategories This category has the following 2 subcategories, out of 2 total.
Anzani 3-cylinder fan engines. ... (ZELL booster) [21] ATAR ... Used Olympus or BS.100 turbomachinery, bypass duct burning and ramjets.
Two booster stages were added to the LP (low pressure) compressor and the last two stages of the HP compressor were removed [6] which increased the overall pressure ratio to 29.3. Although the 86.4 in (2.19 m) diameter fan was retained, the airflow was raised to 1,450 lb/s (660 kg/s), yielding a static thrust of 51,000 lb f (227 kN).
Ads
related to: duct booster fan catalogebay.com has been visited by 1M+ users in the past month
northerntool.com has been visited by 100K+ users in the past month