Search results
Results from the WOW.Com Content Network
Where x is the material type (only 1 is specified so far), yy is the steel group number (specified in EN10027-2) and zz(zz) is a sequential number designated by the certifying body, the number in brackets being unused but reserved for later use.
Many material or standard specifications include a number of different UNS numbers that may be used within that specification. For example: UNS S30400 (SAE 304, Cr/Ni 18/10, Euronorm 1.4301 stainless steel) could be used to make stainless steel bars ( ASTM A276 ) or stainless steel plates for pressure vessels ( ASTM A240 ) or pipes ( ASTM A312 ).
ASTM International, formerly known as American Society for Testing and Materials, is a standards organization that develops and publishes voluntary consensus technical international standards for a wide range of materials, products, systems and services. Some 12,575 apply globally.
ASTM A500 defines four grades of carbon steel based primarily on material strength. [1] This is a standard set by the standards organization ASTM International, a voluntary standards development organization that sets technical standards for materials, products, systems, and services.
The A36 (UNS K02600) standard was established by the ASTM International. The standard was published in 1960 and has been updated several times since. [2] Prior to 1960, the dominant standards for structural steel in North America were A7 (until 1967 [3]) and A9 (for buildings, until 1940 [4]). [5] Note that SAE/AISI A7 and A9 tool steels are ...
ASTM A992 is currently the most available steel type for structural wide-flange beams. The industry's technical institute describes the standard thus: "ASTM A992 (Fy = 50 ksi, Fu = 65 ksi) is the preferred material specification for wide-flange shapes, having replaced ASTM A36 and A572 grade 50. There are a couple of noteworthy enhancements ...
A572 Steel Material Properties, Per ASTM Standards [2]; A572 Grade Yield Point (KSI) [MPa] Tensile Strength (KSI) [MPa] Min. 8” Elongation % Grade 42
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.