enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2 -inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8 -inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming ( S&D ) bits, whose sets run from 9 ⁄ 16 -inch (14 mm) to 1 + 1 ⁄ 2 -inch (38 mm) drill ...

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   The hex head is used to drive the bolt into the countersunk hole, then either a wrench or hammer is used to break the shank and hex head from the flat head, or it is driven until the driving head shears off. Either method leaves only a smooth bolt head exposed. This type of bolt is commonly used with prison door locks, automobile ignition ...

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   carriage bolt: cup head bolt, coach bolt: A carriage bolt, also known as a coach bolt, has a domed or countersunk head, with a shank topped by a short square section under the head. Unlike "regular" bolts, a carriage bolt has a smooth head that does not accept tools; instead, counter-rotation is provided by the square section of shank.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A lathe of 1871, equipped with leadscrew and change gears for single-point screw-cutting A Brown & Sharpe single-spindle screw machine. Fasteners had become widespread involving concepts such as dowels and pins, wedging, mortises and tenons, dovetails, nailing (with or without clenching the nail ends), forge welding, and many kinds of binding with cord made of leather or fiber, using many ...