enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   With lug bolts, on the other hand, the whole hub usually has to be replaced in case of stripped threads in the hub. One motivation for using lug bolts instead of wheel studs and nuts the number of parts that needs to be attached to the wheel hub. Wheel studs and lug nuts consist of two parts, while the lug bolt is a single part.

3. Lug nut - Wikipedia

   en.wikipedia.org/wiki/Lug_nut

   From left: 9 lug nuts and 4 lug nut attached to screw-in wheel studs. A bolt circle with four lug nuts on an Acura. A lug nut or wheel nut is a fastener, specifically a nut, used to secure a wheel on a vehicle. Typically, lug nuts are found on automobiles, trucks (lorries), and other large vehicles using rubber tires.

4. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   Wheel studs are the bolts that are on your mounting hub and are used along with lug nuts to attach the wheel to the car. The bolt hole circle is the circle that the center of each bolt aligns with. The second number in a bolt pattern is the diameter of this circle. [ 2 ]

5. Centerlock wheel - Wikipedia

   en.wikipedia.org/wiki/Centerlock_wheel

   A centerlock wheel is a type of automobile wheel in which the wheel is fastened to the axle using a single, central nut, instead of the more common ring of 4 or 5 lug nuts or bolts. It is mostly used in racing and high end sports cars.

6. Loose wheel nut indicator - Wikipedia

   en.wikipedia.org/wiki/Loose_wheel_nut_indicator

   If too many lug nuts are loosened, the wheel can detach from the wheel stud; loose wheel nut indicators allow identification of loose nuts before this can occur. Loose wheel nut indicators or lug nut indicators are used both by auto mechanics and drivers to identify lug nuts which require tightening, as well as by accident investigators to ...

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...