enow.com Web Search

  1. Ads

    related to: replacing tie rod ends
  2. dormanproducts.com has been visited by 10K+ users in the past month

    • Where To Buy

      Search Where To Find Dorman Product

      Check Your Local Area!

    • Who We Are

      Learn More About Our Long History

      Take Our Virtual Tour Today!

Search results

  1. Results from the WOW.Com Content Network
  2. Rod end bearing - Wikipedia

    en.wikipedia.org/wiki/Rod_end_bearing

    A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

  3. Ball joint - Wikipedia

    en.wikipedia.org/wiki/Ball_joint

    A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...

  4. Steering linkage - Wikipedia

    en.wikipedia.org/wiki/Steering_linkage

    These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the wheel moves over roads.

  5. Drag link - Wikipedia

    en.wikipedia.org/wiki/Drag_link

    "The drag link connects the pitman arm to the steering arm, or in some applications it connects to the tie rod assembly. Unlike a center link, the drag link does not connect to an idler arm, and has no inner tie rod ends attached to it. On some applications the drag link swings from the front to the rear of the vehicle.

  6. Tie rod - Wikipedia

    en.wikipedia.org/wiki/Tie_rod

    The working strength of a tie rod is the product of the allowable working stress and the rod's minimum cross-sectional area. If threads are cut into a cylindrical rod, that minimum area occurs at the root of the thread. Often rods are upset (made thicker at the ends) so that the tie rod does not become weaker when threads are cut into it.

  7. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  1. Ads

    related to: replacing tie rod ends