enow.com Web Search

  1. Ads

    related to: what to use between bricks in garage roof replacement

Search results

  1. Results from the WOW.Com Content Network
  2. Reglet - Wikipedia

    en.wikipedia.org/wiki/Reglet

    A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...

  3. Mortar joint - Wikipedia

    en.wikipedia.org/wiki/Mortar_joint

    Some mortar joint styles. In masonry, mortar joints are the spaces between bricks, concrete blocks, or glass blocks, that are filled with mortar or grout.If the surface of the masonry remains unplastered, the joints contribute significantly to the appearance of the masonry. [1]

  4. Tuckpointing - Wikipedia

    en.wikipedia.org/wiki/Tuckpointing

    Tuckpointing was a way of achieving a similar effect using cheap, unrubbed bricks; these were laid in a mortar of a matching colour (initially red, but later, blue-black bricks and mortar were occasionally used) and a fine fillet of white material, usually pipe clay or putty, pushed into the joints before the mortar set. [4]

  5. Mortar (masonry) - Wikipedia

    en.wikipedia.org/wiki/Mortar_(masonry)

    Mortar holding weathered bricks. Mortar is a workable paste which hardens to bind building blocks such as stones, bricks, and concrete masonry units, to fill and seal the irregular gaps between them, spread the weight of them evenly, and sometimes to add decorative colours or patterns to masonry walls.

  6. Repointing - Wikipedia

    en.wikipedia.org/wiki/Repointing

    German masons repointing a wall in 1948. Repointing is the process of renewing the pointing, which is the external part of mortar joints, in masonry construction. Over time, weathering and decay cause voids in the joints between masonry units, usually in bricks, allowing the undesirable entrance of water.

  7. Brick nog - Wikipedia

    en.wikipedia.org/wiki/Brick_nog

    Brick infill in half-timbered construction. Brick nog (nogging or nogged, [1] beam filling) is a construction technique in which bricks are used to fill the gaps in a wooden frame. Such walls may then be covered with tile, weatherboards, or rendering, or the brick may remain exposed on the interior or exterior of the building.

  1. Ads

    related to: what to use between bricks in garage roof replacement