Search results
Results from the WOW.Com Content Network
Ethernet flow control is a mechanism for temporarily stopping the transmission of data on Ethernet family computer networks. The goal of this mechanism is to avoid packet loss in the presence of network congestion. The first flow control mechanism, the pause frame, was defined by the IEEE 802.3x standard.
Autonegotiation is a signaling mechanism and procedure used by Ethernet over twisted pair by which two connected devices choose common transmission parameters, such as speed, duplex mode, and flow control. In this process, the connected devices first share their capabilities regarding these parameters and then choose the highest-performance ...
In data communications, flow control is the process of managing the rate of data transmission between two nodes to prevent a fast sender from overwhelming a slow receiver. Flow control should be distinguished from congestion control, which is used for controlling the flow of data when congestion has actually occurred. [1]
Since Windows Server 2012, it is enabled by default in Windows Server versions, because Data Center Transmission Control Protocol (DCTCP) is used. [12] In previous Windows versions and non-server versions it is disabled by default. ECN support can be enabled using a shell command such as netsh interface tcp set global ecncapability=enabled.
IEEE 802.3bd provided a mechanism for link-level per priority pause flow control. These new protocols required new hardware and software in both the network and the network interface controller. Products were being developed by companies such as Avaya, Brocade, Cisco, Dell, EMC, Emulex, HP, Huawei, IBM, and Qlogic. [citation needed]
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band , over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively).
Wormhole flow control, also called wormhole switching or wormhole routing, is a system of simple flow control in computer networking based on known fixed links. It is a subset of flow control methods called flit-buffer flow control. [1]: Chapter 13.2.1
In computer networking, a flit (flow control unit or flow control digit) is a link-level atomic piece that forms a network packet or stream. [1] The first flit, called the header flit holds information about this packet's route (namely the destination address) and sets up the routing behavior for all subsequent flits associated with the packet.