Search results
Results from the WOW.Com Content Network
For a circuit to be modelled with an ideal source, output impedance, and input impedance; the circuit's input reactance can be sized to be the negative of the output reactance at the source. In this scenario, the reactive component of the input impedance cancels the reactive component of the output impedance at the source.
In electrical engineering, impedance is the opposition to alternating current presented by the combined effect of resistance and reactance in a circuit. [1]Quantitatively, the impedance of a two-terminal circuit element is the ratio of the complex representation of the sinusoidal voltage between its terminals, to the complex representation of the current flowing through it. [2]
In electrical engineering, impedance matching is the practice of designing or adjusting the input impedance or output impedance of an electrical device for a desired value. Often, the desired value is selected to maximize power transfer or minimize signal reflection .
The input impedance of an infinite line is equal to the characteristic impedance since the transmitted wave is never reflected back from the end. Equivalently: The characteristic impedance of a line is that impedance which, when terminating an arbitrary length of line at its output, produces an input impedance of equal value. This is so because ...
In analog circuits a high impedance node is one that does not have any low impedance paths to any other nodes in the frequency range being considered.Since the terms low and high depend on context to some extent, it is possible in principle for some high impedance nodes to be described as low impedance in one context, and high impedance in another; so the node (perhaps a signal source or ...
Since the impedance included the input capacitance and the probe is an impedance divider circuit, the result is that the waveform being measured is not distorted by the RC circuit formed by the probe resistance and the capacitance of the input (or the cable capacitance which is generally higher). [32] [33]
A Canadian woman allegedly attempted to smuggle 22 pounds of methamphetamine wrapped as Christmas presents through a New Zealand airport on Sunday, Dec. 8.
where division is used because the input connection is shunt: the feedback two-port is in parallel with the signal source at the input side of the amplifier. A reminder: A OL is the loaded open loop gain found above, as modified by the resistors of the feedback network. The impedance seen by the load needs further discussion.