Search results
Results from the WOW.Com Content Network
The medium-duty 1930 A-series trucks received the all-new 278.7 cu in (4.6 L) FB-3 six-cylinder engine, with overhead valves and seven main bearings. This was complemented by larger versions of the same engine and was built until late 1940 (as the FBB), [7] the line-up being expanded downward by the smaller FA-series (later FAB) in 1933. [8]
The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.
The flame-start system is a cold start aid for starting diesel engines at low ambient temperatures. It reduces the white smoke emission after the engine is started. In addition, it reduces the strain on the starter motor and batteries by shortening the start-up time. [1]
A direct start system as used on a marine slow-speed diesel is required to have up to 12 starts on a non-reversing engine or 6 starts on a reversible, or geared, engine. When starting the engine, compressed air is admitted to whichever cylinder has a piston just over top dead center, forcing it downward. [2]
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
The 351 or 351C were used in some 4000, 5000, and 6000 series trucks from 1962 to 1972 and the 351E was used in the 1000–3500 series trucks from 1966 to 1969. [13] The 351, 351C, and 351M engines were medium duty truck engines, while the 351E was a light-duty engine – basically a 351M without the oil-driven governors.
The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web. AOL.
Starting fluid is sprayed into the engine intake near the air filter, or into the carburetor bore or a spark plug hole of an engine to get added fuel to the combustion cylinder quickly. Using starting fluid to get the engine running faster avoids wear to starters and fatigue to one's arm with pull start engines, especially on rarely used machines.