enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 4.3-10 connector - Wikipedia

   en.wikipedia.org/wiki/4.3-10_connector

   universal support for hex-wrench, hand-tighten and quick-release couplings; The footprint was decreased by reducing the outer conductor diameter from 16 to 10 mm, which lowers the power rating, but allows a connection density of 1 connector per inch (2.54 cm), in line with other connectors such as DIN 4.1/9.5 or N connectors. [3]

3. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   Side view of a 1.5 to 2.5 inches (38 to 64 mm) adapter. National Hose thread (NH), also known as National Standard Thread (NST). It is the most common type of fire hose coupling used in the United States.

4. Caliber conversion device - Wikipedia

   en.wikipedia.org/wiki/Caliber_conversion_device

   The most commonly encountered supplemental chambers are for .30 caliber rifles designed for .308-inch (7.8 mm) diameter bullets, to use .32 caliber handgun cartridges with bullet diameters of approximately .312-inch (7.9 mm). Cartridge adapters have also been made to use .38 caliber handgun cartridges with bullet diameters of approximately .357 ...

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow.

7. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.