Search results
Results from the WOW.Com Content Network
The frequency response for a conventional LP player might be 20 Hz to 20 kHz, ±3 dB. The low-frequency response of vinyl records is restricted by rumble noise (described above), as well as the physical and electrical characteristics of the entire pickup arm and transducer assembly. The high-frequency response of vinyl depends on the cartridge.
An audio frequency or audible frequency (AF) is a periodic vibration whose frequency is audible to the average human. The SI unit of frequency is the hertz (Hz). It is the property of sound that most determines pitch. [1] The generally accepted standard hearing range for humans is 20 to 20,000 Hz.
The higher frequency sound waves have a shorter wavelength and thus don't spread out as rapidly. For this reason, the resulting directivity of these devices is far higher than physically possible with any loudspeaker system. However, they are reported to have limited low-frequency reproduction abilities. See sound from ultrasound for more ...
High frequency [18] VHF: 0.03 to 0.3 GHz: Very high frequency [18] UHF: 0.3 to 1 GHz: Ultra-high frequency [18] L: 1 to 2 GHz: Long wave S: 2 to 4 GHz: Short wave C: 4 to 8 GHz: Compromise between S and X X: 8 to 12 GHz: Used in World War II for fire control, X for cross (as in crosshair). Exotic. [19] K u: 12 to 18 GHz: Kurz-under K: 18 to 27 ...
The first research on the topic of how the ear hears different frequencies at different levels was conducted by Fletcher and Munson in 1933. Until recently, it was common to see the term Fletcher–Munson used to refer to equal-loudness contours generally, even though a re-determination was carried out by Robinson and Dadson in 1956, which became the basis for an ISO 226 standard.
A graph of amplitude vs frequency (not time) for a single sinusoid at frequency 0.6 f s and some of its aliases at 0.4 f s, 1.4 f s, and 1.6 f s would look like the 4 black dots in Fig.3. The red lines depict the paths ( loci ) of the 4 dots if we were to adjust the frequency and amplitude of the sinusoid along the solid red segment (between f ...
A "rumble filter" is a high-pass (low cut) filter with a cutoff typically in the 20 to 40 Hz range; this is the low frequency end of human hearing. "Rumble" is a type of low-frequency noise produced in record players and turntables, particularly older or low quality models.
When a bandpass signal is sampled slower than its Nyquist rate, the samples are indistinguishable from samples of a low-frequency alias of the high-frequency signal. That is often done purposefully in such a way that the lowest-frequency alias satisfies the Nyquist criterion, because the bandpass signal is still uniquely represented and ...