enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Shaft alignment - Wikipedia

   en.wikipedia.org/wiki/Shaft_alignment

   Before shaft alignment can be done, the foundations for the driver and the driven piece must be designed and installed correctly. [citation needed]Flexible couplings are designed to allow a driver (e.g., electric motor, engine, turbine, hydraulic motor) to be connected to the driven equipment.

3. Spline (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Spline_(mechanical)

   For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear. Adjacent images in the section below show a transmission input shaft with male splines and a clutch plate with mating female splines in the center hub, where the smooth tip of the axle would be supported in a pilot bearing in ...

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Slot screw drives have a single horizontal indentation (the slot) in the fastener head and is driven by a "common blade" or flat-bladed screwdriver.This form was the first type of screw drive to be developed, and, for centuries, it was the simplest and cheapest to make because it can just be sawed or filed.

5. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...

6. Wiggler (tool) - Wikipedia

   en.wikipedia.org/wiki/Wiggler_(tool)

   Centering of a shaft with a laser centering device. A centering device is a tool used to accurately adjust and align the center plane or axis of a work piece or work piece feature to the machining center. In contrast to the edge finder, it most often requires no calculation, measurements or layout method markings to allow this alignment.

7. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   Indexable bits with the same purpose, to be held either in indexable handles or in power tool chucks, are called nutsetters. A spinner handle is a shaft and handle with a drive fitting—most commonly 1 ⁄ 4 in (6.35 mm) square axle at the end for attaching interchangeable sockets. This allows one to use a single handle with a number of sizes ...