enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Castability - Wikipedia

    en.wikipedia.org/wiki/Castability

    If a design requires a high degree of accuracy, fine surface finish or defect free surface it reduces the castability of the part. [2] However, the casting process can be very economical for part designs that require intricate contoured surfaces, thickness variations, and internal features.

  3. Directional solidification - Wikipedia

    en.wikipedia.org/wiki/Directional_solidification

    Directional solidification is the preferred technique for casting high temperature nickel-based superalloys that are used in turbine engines of aircraft. Some microstructural problems such as coarse dendritic structure, long dendrite side branches, and porosity hinder the full potential of single crystal ni-based alloys. [ 6 ]

  4. Design of plastic components - Wikipedia

    en.wikipedia.org/wiki/Design_of_plastic_components

    Draft angle design is an important factor when designing plastic parts. Because of shrinkage of plastic material, injection molded parts have a tendency to shrink onto a core. This creates higher contact pressure on the core surface and increases friction between the core and the part, thus making ejection of the part from the mold difficult.

  5. Chvorinov's rule - Wikipedia

    en.wikipedia.org/wiki/Chvorinov's_rule

    Where t is the solidification time, V is the volume of the casting, A is the surface area of the casting that contacts the mold, n is a constant, [clarification needed] and B is the mold constant. This relationship can be expressed more simply as: = Where the modulus M is the ratio of the casting's volume to its surface area:

  6. Casting - Wikipedia

    en.wikipedia.org/wiki/Casting

    The solidified part is also known as a casting, which is ejected or broken out of the mold to complete the process. Casting materials are usually metals or various time setting materials that cure after mixing two or more components together; examples are epoxy, concrete, plaster and clay. Casting is most often used for making complex shapes ...

  7. Metal injection molding - Wikipedia

    en.wikipedia.org/wiki/Metal_injection_molding

    The powder injection molding process Complex geometry in one component instead of an assembly of many items Eyeglass components produced by powder injection molding. In the monograph P.O. Gribovsky, published in 1956, describes in detail the technology of hot casting (hot molding) ceramic products under pressure (now, Low Pressure Powder Injection Molding) and, in particular, notes that "hot ...

  8. Core (manufacturing) - Wikipedia

    en.wikipedia.org/wiki/Core_(manufacturing)

    A core is a device used in casting and moulding processes to produce internal cavities and reentrant angles (an interior angle that is greater than 180°). The core is normally a disposable item that is destroyed to get it out of the piece. [1] They are most commonly used in sand casting, but are also used in die casting and injection moulding.

  9. Pattern (casting) - Wikipedia

    en.wikipedia.org/wiki/Pattern_(casting)

    The exact process and pattern equipment is always determined by the order quantities and the casting design. Sand casting can produce as little as one part, or as many as a million copies. Although additive manufacturing modalities such as SLS or SLM have potential to replace casting for some production situations, casting is still far from ...