enow.com Web Search

  1. Ads

    related to: analog multimeter scale reading

Search results

  1. Results from the WOW.Com Content Network
  2. Class of accuracy in electrical measurements - Wikipedia

    en.wikipedia.org/wiki/Class_of_accuracy_in...

    In electrical engineering, characteristics like current or voltage can be measured by an ammeter, a voltmeter, a multimeter, etc.The ammeter is used in series with the load, so the same current flows through the load and the ammeter.

  3. Multimeter - Wikipedia

    en.wikipedia.org/wiki/Multimeter

    For example, if the meter is set to a range of 300 V full scale, the meter's impedance will be 6 MΩ. 20,000 Ω/V is the best (highest) sensitivity available for typical analog multimeters that lack internal amplifiers.

  4. Accuracy class - Wikipedia

    en.wikipedia.org/wiki/Accuracy_class

    Class 0.5 is an ANSI C12.20 accuracy class for electric meters with absolute accuracy better than ± 0.5% of the nominal full scale reading. [1] Typically, a class specifies accuracy at a number of points, with the absolute accuracy at lower values being better than the nominal "percentage of full scale" accuracy.

  5. Full scale - Wikipedia

    en.wikipedia.org/wiki/Full_scale

    The amplitude of a digital signal can be represented in percent; full scale; or decibels, full scale (dBFS). In analog systems, full scale may be defined by the maximum voltage available, or the maximum deflection (full scale deflection or FSD) or indication of an analog instrument such as a moving coil meter or galvanometer.

  6. Analog voltmeter - Wikipedia

    en.wikipedia.org/wiki/Voltmeter

    The sensitivity of such a meter can be expressed as "ohms per volt", the number of ohms resistance in the meter circuit divided by the full scale measured value. For example, a meter with a sensitivity of 1000 ohms per volt would draw 1 milliampere at full scale voltage; if the full scale was 200 volts, the resistance at the instrument's ...

  7. S meter - Wikipedia

    en.wikipedia.org/wiki/S_meter

    Analogue S meters are actually sensitive microammeters, with a full scale deflection of 50 to 100 μA. In AM receivers, the S meter can be connected to the main detector or use a separate detector at the final IF stage. This is the preferred method for CW and SSB receivers. Another approach in the days of electronic tubes (valves) was to ...

  1. Ads

    related to: analog multimeter scale reading