enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Mechanically aided scrubber - Wikipedia

   en.wikipedia.org/wiki/Mechanically_aided_scrubber

   Figure 2 - Induced spray scrubber. There are fewer mechanically aided scrubber designs available than liquid- and gas-phase contacting collector designs. Two are more common: centrifugal fan scrubbers and mechanically induced spray scrubbers. A centrifugal-fan scrubber can serve as both an air mover and a collection device. Figure 1 shows such ...

3. This cordless electric scrubber (down to $40!) is a must-have ...

   www.aol.com/lifestyle/this-cordless-electric...

   The Bell & Howell Rechargeable Scrubber Pro Deluxe, now on sale for $40, comes with nine brush heads for cleaning your shower, floorboards, windows, ceiling fans, tight corners, car and pretty ...

4. Cyclonic spray scrubber - Wikipedia

   en.wikipedia.org/wiki/Cyclonic_spray_scrubber

   Cyclonic scrubbers are generally low- to medium-energy devices, with pressure drops of 4 to 25 cm (1.5 to 10 in) of water. Commercially available designs include the irrigated cyclone scrubber and the cyclonic spray scrubber. In the irrigated cyclone (Figure 1), the inlet gas enters near the top of the scrubber into the water sprays. The gas is ...

5. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   The length of the nipple is usually specified by the overall length with thread. It may have a hexagonal section in the center for a wrench to grasp (sometimes referred to as a "hex nipple"), or it may simply be made from a short piece of pipe (sometimes referred to as a "barrel nipple" or "pipe nipple").

6. AOL

   search.aol.com

   The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.

7. Ball valve - Wikipedia

   en.wikipedia.org/wiki/Ball_valve

   A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet, and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]