Search results
Results from the WOW.Com Content Network
A sawed-off break-action shotgun of the type commonly known as a lupara. A sawed-off shotgun (also called a scattergun, sawn-off shotgun, short-barrelled shotgun, shorty, or boom stick) is a type of shotgun with a shorter gun barrel—typically under 18 inches (46 cm)—and often a pistol grip instead of a longer shoulder stock.
Therefore, when the barrel recoils the inertial force from the breech produces a moment on the rear end of the barrel. This causes a wave to travel down the barrel which quickly overtakes the shot and results in a deflection of the muzzle before shot exit. Figure 6 shows the typical response of a tank gun barrel for an off-axis breech.
Tapered barrel of a cannon. In barrels , this centralises mass to the operator. Not only to reduce weight from the muzzle but also to increase accuracy / acquisition and stabilise the balance handling of the weapon.
A bullet trap (or pellet trap when used specifically for air guns) is a device to stop and collect projectiles fired at a shooting range to prevent overpenetrations and stray shots. Bullet traps typically use friction, impact or gradual deceleration to stop bullets.
The wood forearm of a Browning BLR. In firearms, the forearm (also known as the fore-end/forend, handguard or forestock) is a section of a gunstock between the receiver and the muzzle. It is used as a gripping surface to hold the gun steady and is usually made out of heat-insulating material such as wood or reinforced plastic.
A view of the break-action of a typical over-and-under (O/U) double-barreled shotgun, with action open and the ejectors visible Two .410 shells being loaded into a side-by-side, double-barrel shotgun A double-barreled shotgun , also known as a double shotgun , is a break-action shotgun with two parallel barrels , allowing two single shots that ...
Close-up of an IOF 32 break-action revolver. The first break-action revolver was patented in France and Britain at the end of December in 1858 by Devisme. [1] A substantial hinge pin joins the two parts of the rifle or shotgun; the stock with its firing mechanism and the fore-piece and barrel, which hold the round to be fired.
The final result is a barrel that is mirror-smooth, and with a consistent or slightly tapering bore. The hand-lapping technique uses a wooden or soft metal rod to pull or push the slug through the bore, while the newer fire-lapping technique uses specially loaded, low-power cartridges to push abrasive-covered soft-lead bullets down the barrel.