Search results
Results from the WOW.Com Content Network
The blank solution should be the same pH and of a similar ionic strength as the sample solution. Example: using water for the blank measurement for samples dissolved in TE may result in low 260/230 ratios. A260/A280 Residual phenol or other reagent associated with the extraction protocol. A very low concentration (< 10 ng/μL) of nucleic acid.
where [A] 0 is the amount, absorbance, or concentration of substrate initially present and [A] t is the amount, absorbance, or concentration of that reagent at time, t. Normalizing data to fractional conversion may be particularly helpful as it allows multiple reactions run with different absolute amounts or concentrations to be compared on the ...
Absorbance is defined as "the logarithm of the ratio of incident to transmitted radiant power through a sample (excluding the effects on cell walls)". [1] Alternatively, for samples which scatter light, absorbance may be defined as "the negative logarithm of one minus absorptance, as measured on a uniform sample". [2]
The equation displayed on the chart gives a means for calculating the absorbance and therefore concentration of the unknown samples. In Graph 1, x is concentration and y is absorbance, so one must rearrange the equation to solve for x and enter the absorbance of the measured unknown. [25]
The pH of a solution is defined as the negative logarithm of the concentration of H+, and the pOH is defined as the negative logarithm of the concentration of OH-. For example, the pH of a 0.01M solution of hydrochloric acid (HCl) is equal to 2 (pH = −log 10 (0.01)), while the pOH of a 0.01M solution of sodium hydroxide (NaOH) is equal to 2 ...
For example, if the concentration of the conjugate base is 10 times greater than the concentration of the acid, their ratio is 10:1, and consequently the pH is pK a + 1 or pK b + 1. Conversely, if a 10-fold excess of the acid occurs with respect to the base, the ratio is 1:10 and the pH is p K a − 1 or p K b − 1.
The pH of a buffer solution depends solely on the ratio of the molar concentrations of the weak acid to the weak base. The higher the concentration of the weak acid in the solution (compared to the weak base) the lower the resulting pH of the solution. Similarly, if the weak base predominates the higher the resulting pH. [citation needed]
This reaction is rapid and stoichiometric, with the addition of one mole of thiol releasing one mole of TNB. The TNB 2− is quantified in a spectrophotometer by measuring the absorbance of visible light at 412 nm, using an extinction coefficient of 14,150 M −1 cm −1 for dilute buffer solutions, [4] [5] and a coefficient of 13,700 M −1 cm −1 for high salt concentrations, such as 6 M ...