Search results
Results from the WOW.Com Content Network
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
A driver communicates with the device through the computer bus or communications subsystem to which the hardware connects. When a calling program invokes a routine in the driver, the driver issues commands to the device (drives it). Once the device sends data back to the driver, the driver may invoke routines in the original calling program.
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
Peripheral Component Interconnect (PCI) [3] is a local computer bus for attaching hardware devices in a computer and is part of the PCI Local Bus standard. The PCI bus supports the functions found on a processor bus but in a standardized format that is independent of any given processor's native bus.
The System Management Bus (SMBus or SMB) is a single-ended simple two-wire bus for the purpose of lightweight communication. Most commonly it is found in chipsets of computer motherboards for communication with the power source for ON/OFF instructions. The exact functionality and hardware interfaces vary with vendors.
SPI lends itself to a "bus driver" software design. Software for attached devices is written to call a "bus driver" that handles the actual low-level SPI hardware. This permits the driver code for attached devices to port easily to other hardware or a bit-banging software implementation.
As computers became more accessible to the general public, the need developed for more frequent changes to be made by computer users unskilled with using soldering irons. Rather than cutting and soldering connections, configuration was accomplished by jumpers or DIP switches. Later on this configuration process was automated: Plug and Play. [6]
The bus driver object is at the bottom of the driver stack, and interacts with the hardware abstraction layer, which is part of the Windows operating system kernel and allows Windows operating systems to run on a variety of processors, different memory management unit architectures, and a variety of computer systems with different I/O bus ...